Back to the '72 GT...
Built a simple engine stand on casters. No welding required.
Front and rear suspensions and transmission removed and degreased.
Wiring harness fully removed. It looks quite intimidating in this state.
Subscribe to:
Post Comments (Atom)
-
Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched. Inner ... -
Previously, I noted that the front left wing lower portion had some rust-through. So this entire lower section will be replaced with new. ... -
Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...
No comments:
Post a Comment