New sheetmetal being welded in. Radiator duct, slam panel. Alignment is critical here for the rest of the front bodywork to fit properly.
Subscribe to:
Post Comments (Atom)
-
Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched. Inner ... -
Repair work to the right-hand side dogleg was virtually the same as the left-hand side. Inside rocker looked much the same as the other si...
-
Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...
No comments:
Post a Comment