Saturday, November 13, 2021

More front body panel fitting

Paint stripping, fine-tuning the metalwork, and testing fit of wings. At this stage all the front sheetmetal has been stripped and media blasted to bare steel.

 



 
 
 
With the front wings bolted up securely all around now, the door gap and alignment can be checked and adjusted. All metalwork has to fit perfectly before preparing for the paint.

 

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Dogleg rust repairs
     Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched.   Inner ...
  • Passenger side dogleg
     Repair work to the right-hand side dogleg was virtually the same as the left-hand side.  Inside rocker looked much the same as the other si...
  • LF Wing lower panel replacement : replacement
     Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...