Monday, August 8, 2022

Rotisserie completed

 I set up the 10' x 10' Harbor Freight 'portable shed' as my sandblasting and pain booth. All the rotisserie bits got two coats of black epoxy 2K primer.

Painted and fully assembled

It works, yay! 

The rotisserie is done. Mostly. I still have a couple details to finish. Need to add springs to the rotation lock pins, and need to find a few working heights where I'll drill holes in the vertical risers to add locking pins. Don't want to just rely on the hydraulic rams to hold the position.







at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Dogleg rust repairs
     Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched.   Inner ...
  • Passenger side dogleg
     Repair work to the right-hand side dogleg was virtually the same as the left-hand side.  Inside rocker looked much the same as the other si...
  • LF Wing lower panel replacement : replacement
     Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...