Got the topsides sprayed with 2 coats of PPG Shopline JP375 2K epoxy primer. With the total strip, all areas had to be sprayed - every nook and cranny. This means the spray gun had to reach into a lot of awkward spots at non-ideal angles for spraying. As a result there's a lot of overspray induced texture that will need to get sanded later. But at least it's not going to get rusty in the meantime.
Saturday, July 2, 2022
First coats of epoxy primer
Subscribe to:
Post Comments (Atom)
-
Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched. Inner ...
-
Previously, I noted that the front left wing lower portion had some rust-through. So this entire lower section will be replaced with new. ...
-
Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...
No comments:
Post a Comment