Wednesday, April 8, 2020

Rear wing panel beating

If I'd known it was so bad before doing the dogleg and the rear panels I'd have just gone for the full replacement wing. It aint pretty, but I think it will do. Got everything within a mm or two of where it belongs. This will mostly fill with just a skim coat. 





at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Dogleg rust repairs
     Cleaned away the rust from the rocker with a wire wheel, and it revealed some rust through. So this would be cut out and patched.   Inner ...
  • Passenger side dogleg
     Repair work to the right-hand side dogleg was virtually the same as the left-hand side.  Inside rocker looked much the same as the other si...
  • LF Wing lower panel replacement : replacement
     Before fitting the new replacement panel, the attachment surfaces on the wing need to be cleaned up and prepared for welding. But there ...